Crankshaft Mounting Tool, for pulling the crankshaft into the generator crankcase half

Crankshaft Insertion Tool

• Especially with crankshaft bearings, it is important that they are installed properly and with correct use of force in order to avoid damage
• This tool is used to pull the crankshaft evenly into the previously mounted bearing in the housing
• Not suitable for pulling in the crankshaft on the clutch side. Please refer to the workshop manual for the correct installation of the crankshaft
• Nuts supplied: 1x M12x1.25, 1x M10x1.25
• Suitable for SR500, TT500 and XT500